...
To configure Periscope, go to http://(IP address of the Web Supervisor/JACE)/periscopeconfig and log in as a super user. Initial Periscope setup must be performed by a super user. Under the locations tab, add several locations or buildings by selecting the new location button at the bottom of the screen. Also make sure to enter a square footage and a blended rate for electricity, and other utilities as desired. At least one trend, point, meter, or web/PX page should be added before accessing Periscope. Periscope’s automatic discovery wizard will instantly import all available numeric points and trends, as well as any meters or PX pages discovered in the Web Supervisor/JACE database. Any additional variables added after the initial discovery will not show up in Periscope until the user does a manual discovery. This is done by pressing the “discover” button at the bottom of the respective variable’s configuration screen. Once configured, the user can access Periscope by going to http://(IP address of the Web Supervisor/JACE)/periscope and entering their credentials.
...