...
• Drag and drop the PeriscopeService from the pallete into your station's Services
• Perform the basic dashboard user setup (see below)
• After which, Periscope installation will be complete and you may open Periscope by going to http:/(IP address of the Web Supervisor/JACE)/periscope
User Setup
Users cannot be created until there is a CategoryService for the dashboard users. To set this up, first navigate to Category Service > Category Manager via the drop-down on the right side after selecting the Category Service.
Then, click "New" at the bottom of the window to add a new category called whatever you like ("Periscope" or "DashboardUser" are recommended) and configure that category via the Category Browser.
All users are capable of accessing their own Periscope dashboard if they meet these requirements:
- Operator Read access to all mapped points is enabled
- Admin Invoke on the PeriscopeService, Meter and Rollover objects
Below is an example configuration of this category:
Finally, navigate to the user that was created earlier specifically for dashboard purposes and click the arrows beside "permissions"
and ensure that the newly created category for the dashboard user is set up like so:
• Periscope has now been successfully installed on your Web Supervisor.
Initial Periscope Configuration
To configure Periscope, go to http://(IP address of the Web Supervisor/JACE)/periscopeconfig and log in as a super user. Under the locations tab, add several locations or buildings by selecting the new location button at the bottom of the screen. Also make sure to enter a square footage and a blended rate for electricity, and other utilities as desired. At least one trend, point, meter, or web/PX page should be added before accessing Periscope. Periscope’s automatic discovery wizard will instantly import all available numeric points and trends, as well as any meters or PX pages discovered in the Web Supervisor/JACE database. Any additional variables added after the initial discovery will not show up in Periscope until the user does a manual discovery. This is done by pressing the “discover” button at the bottom of the respective variable’s configuration screen. Once configured, the user can access Periscope by going to http://(IP address of the Web Supervisor/JACE)/periscope and entering their credentials.
User Setup
All users are capable of accessing their own Periscope dashboard if they meet these requirements:
- Operator Read access to all mapped points is enabled
- Admin Invoke on the PeriscopeService, Meter and Rollover objects
You can open Periscope by going to http://(IP address of the Web Supervisor/JACE)/periscope
...